- Manuals
- Brands
- DILISS Manuals
- Two-Way Radio
- T-388
- User manual
Kids walkie talkie
Hide thumbs
-
- Contents
- Table of Contents
- Troubleshooting
- Bookmarks
Advertisement
Table of Contents
- 1 Product Inspection
- 2 Radio Parts and Controls
- 3 Product Features
- 4 Installation
- 5 Operation
- 6 Channel Lock
- 7 Select Channel
- 8 Troubleshooting
- 9 Approved Accessories
- Download this manual
SCAN
SCAN
T-388
Kids Walkie Talkie
User's Guide
US
Table ofContents
Advertisement
Table of Contents
Summary of Contents for DILISS T-388
- Page 1 SCAN SCAN T-388 Kids Walkie Talkie User’s Guide...
-
Page 2: Product Inspection
Read this operating instruction carefully before using your DILISS RT388 two way Antenna radio, including the part on Product Safety and RF Energy Exposure Compliance CAUTION Channel / Menu Item Product Inspection Scanning CTCSS / Before initial use, please check if the product inside the Menu Option box is in good condition or not. - Page 3 Various information accessible at one glance, including Product Features channel number, CTCSS code, volume level and other status of the radio. TECHNICAL PARAMETERS Product number T-388 On/Off Power Button Frequency range Press and hold this button to turn on/off the radio. Channel number Channel spacing 12.5KHz...
-
Page 4: Installation
How to install or replace batteries RECEIVER Make sure the radio is turned off; The sensitivity ≤0.2uV Remove the belt clip; Modulation receiver bandwidth ±5KHz Slide and lift the battery compartment cover; Adjacent selective ≥40dB Insert 4 AAA batteries with correct polarity into per radio; Intermodulation interference resistance ≥35dB Close the battery cover and attach the belt clip. -
Page 5: Channel Lock
Turning off the radio Channel Lock Press and hold until an audible beep is heard and Press and hold MENU button until the screen disappears. icon appears on the screen, which indicates that the radio is locked to Adjusting volume level the current channel, namely, you Use the up/down key to increase or cannot switch it to another channel... - Page 6 Set CTCSS Code tone to their radios. Within a channel, you can partly Press MENU button four times, avoid interference from other radios then “CA” and call tone number by setting CTCSS code (01-38) (01, 02, 03, 04, 05, 06, 07, 08, 09, while code 00 refers to no privacy 10) will blink on the screen;...
- Page 7 1.The receiving unit is on the same channel and shares Then you can charge the units by the same CTCSS code as the unit that sends the call plugging the charger(not included)’s tone; connector into the accessory jack 2. The receiving unit is within the communication range. and then connect the other end of the charger to a general socket or Monitor...
-
Page 8: Troubleshooting
Guarantee receive weak signals Model Number: B. Check battery level Serial Number: The Stylized DILISS logo are trademarks or register- Purchasing Date: ed trademarks of Shenzhen HuiKe Electronics Co., Dealer: Ltd. And are used under license. All other trademarks Telephone: are the property of their respective owners. - Page 9 RF energy, however, should not label directing users to specific user awareness be confused with these other forms of electromagnetic information. Your DILISS walkie talkie has a RF energy, which when used improperly, can cause Exposure Product Label. Also, your DILISS user biological damage.
- Page 10 Safety Marking) Your DILISS walkie talkie complies with the following Your DILISS walkie talkie is designed and tested to RF energy exposure standards and guidelines: comply with a number of national and International • United States Federal Communications Commission standards and guidelines (listed below) for human (FCC), Code of Federal Regulations;...
- Page 11 • When operating in front of the face, worn on the body, Note: Nearly every electronic device is susceptible to always place the radio in a DILISS approved clip, electromagnetic interference (EMI) if inadequately holder, holster, case, or body harness for this product.
- Page 12 To avoid electromagnetic interference and/ from the implantable device to minimize the or compatibility conflicts potential for interference. • Turn off your radio in any facility where posted notices instruct you to do so, hospitals or - Hearing Aids health care facilities (Pacemakers, Hearing Some digital wireless radios may interfere with Aids and Other Medical Devices) may be some hearing aids.
-
Page 13: Approved Accessories
• Do not place a portable radio in the area over • For a list of DILISS-approved accessories for an air bag or in the air bag deployment area. your radio model, visit the following website: The radio may be propelled with great force http://www.diliss.com... - Page 14 Shenzhen Huike Electronics Co., Ltd. Web:www.diliss.com E-mail:Joe@diliss.com Facebook：facebook.com/diliss...
